NL2100 is a lightweight rubber hose that offers superior flexibility and a good 'force-to-bend' radius over urethane material handling hoses. It is designed for the transfer of light debris, small materials (wet or dry), leaves, or sand from storm sewers; this hose is NOT recommended for use on Hydro Excavating/Vacuum (psi/hg ratings at 20C/70F). It has an 'all rubber wall' which will gradually wear out providing more longevity, unlike urethane lined/tube hoses which can fail quickly once the relatively thin tube breaks down. It has a smooth, static-dissipative, SBR rubber tube which eliminates material build-up in the hose and provides electrical conductivity. Its cover is highly resistant to UV and weathering. Also available in Kanaflex 180AR brand (NL2105). *Service life of material handling hoses may vary depending on the operating conditions, hours of use, and the product being conveyed. Always rotate the hose regularly for even wear and inspect the tube for degradation before use.

Construction: Tube: Smooth SBR rubber. Cover: Corrugated SBR rubber. Reinforcement: Rigid, right hand (clockwise) PVC helix.

Typical Fittings: Insert type fittings can wear out prematurely with highly abrasive products; N675 right hand spiral clamps, N51 double bolt clamps. Note: Spiral clamps or N70-C2xx strapping must be used for proper sealing with wet materials.

Temperature Range: -40°C (-40°F) to +60°C (140°F)

Detail Comments: Service life of material handling hoses may vary depending on the operating conditions, hours of use, and the product being conveyed. Always rotate the hose regularly for even wear and inspect the tube for degradation before use. Continuous flexing of a hose within 18 inches of a fitting is a common cause of hose failure. We recommend installing a 12 to 16 inch section of Banding Coil to the hose end that is over flexing.

Cut Method: Sawzall or Hacksaw - Wear Safety Gloves