NL8209 is a competitively priced alternative to domestically manufactured concrete hoses on the market. It is a durable, long lasting and kink resistant hose. Suitable for plaster, grout, wet shotcrete, for buildings, swimming pools, or construction sites. Service life of material handling hoses may vary depending on the operating conditions, hours of use, and the product being conveyed. Always rotate the hose regularly for even wear and inspect the tube for degradation before use. *SPECIAL NOTE: Concrete hose is typically not repaired as the wall/tube will wear down and therefore the coupling integrity is significantly compromised if re-installing an end.

Construction: Tube: Synthetic and natural rubber blend compound, black, smooth, highly abrasion resistant. Cover: Smooth with cloth impression, abrasion, ozone and weather resistant. Reinforcement: Multiple layers of high tensile textile cord fabric and anti-static copper wire.

Typical Fittings: Typical Fittings: WFT-CS Heat treated swaged ends (HD California flanged ends for concrete pump hose, DO NOT use Grooved or NPT ends for concrete pump service). For 1"-1-1/2" Grout Lines, N95- Galvanized Internal Expansion Ends and NH42-xxxSS/NH45-xxxSS HD Camlocks may be used in certain applications. Use with Whipcheck Safety Cables & Nylon Slings (must be properly installed in an extended position).

Temperature Range: -30°C (-22°F) to +85°C (185°F)

Detail Comments: Working pressures shown based on this hose being used to transfer concrete, not for water or other fluids. For non-concrete applications the working pressure will vary depending on the safety factor required (as an example for water, certain sizes could be rated to 500-600 psi).

Warning: Critical Application-Follow Coupling/Maintenance Procedures