This is a thin, light duty, economical vinyl air vent or blower hose used for bilge venting on boats (for a flame resistant hose see our NL6035 HTR Ducting) or bathroom fans. It is not recommended for use on residential dryers due to its temperature limitations and lint build up from its corrugated interior (use residential flexible aluminum or sheet metal ducting meant for dryers).

Construction: White (NL6001) or black (NL6002) vinyl with a steel wire helix.

Typical Fittings: N62/N64 gear clamps, T7-200X180 duct tape; this hose is typically not used with fittings.

Temperature Range: -20°C (-4°F) to +65°C (150°F)

Detail Comments: All ducting is measured when fully extended.

Warning: Ducting is Measured/Cut when Fully Stretched.

Cut Method: Sawzall or Hacksaw & Side Snips for Wire-Wear Safety Gloves

Marketing: NOT for use as a Dryer Vent/Hot Air.