This Air-On-Demand (AOD) kit is designed for a home garage or small shop setup, typically a single user about 50ft from the compressor. This kit can be run along ceilings, walls, or benches and provides parts needed for 2 outlets. Additional outlets (sold separately) can be added, however refer to the CFM Flow Rate Usage Chart. Prior to starting the installation, determine a suitable layout. For draining of condensation buildup in lines, vertical drops should have a drain valve (included) threaded into the bottom of the aluminum manifold, and horizontal runs should have the valve threaded into the last manifold. Condensation in air systems should be drained at regular intervals. Filters, Regulators & Lubricators are recommended in any compressed air system (sold separately). After the layout is determined, thread all tube fittings to aluminum manifolds using PTFE Thread Tape. Mount manifolds directly to bench, walls or ceilings using suitable hardware, locating a stud or joist if mounting through wallboard. Thread MNPT x Tube fitting into the compressor or air source. Use support clamps (included) to secure tubing for safe and tidy routing.

Typical Fittings: The AOD system includes quality push-in fittings, air distribution manifolds, and nylon tubing.

Detail Comments: The maximum operating pressure is 150PSI. For safety, do not exceed the pressure limitation of the tubing, hose and/or device you are using. Failure to follow these directions exactly may result in personal injury and/or property damage. Do not point compressed air source at any part of your body or at any person. Always use eye protection when using compressed air.